Free referral line · Independent guides, every cost sourced Calls answered 24/7 for water emergencies · 1-800-555-0199

Basements & Crawl Spaces · Cost guide

Sump Pump Installation and Replacement Cost

Sump pump installation cost and sump pump replacement cost, pedestal vs submersible, how long sump pumps last, signs of sump pump failure, and sump pump repair.

Short answer

Sump pump installation costs about $600 to $2,500 including the pit and labor; the pump itself is $100 to $800, and labor is $500 to $1,700 (HomeGuide). Replacing an existing pump costs about $645 to $2,102, around $1,353 on average (HomeAdvisor). Most pumps last about 7 to 10 years; pedestal pumps often last longer than submersible ones.

A sump pump is the last line of defense for many basements and crawl spaces. When it fails during a storm, the basement floods. Knowing what installation and replacement cost, and when a pump is near the end of its life, avoids that surprise.

Sump pump installation cost

Item Typical cost
New installation (pit, pump, discharge) $600 – $2,500
Pump unit only $100 – $800
Labor $500 – $1,700
Replacement (existing pit) $645 – $2,102 (avg $1,353)
Minor repair (switch, float) $100 – $300

Sources: HomeGuide, HomeAdvisor, Angi.

A simple new installation takes about 8 to 10 hours, longer if concrete has to be broken for the pit or new electrical and plumbing is needed.

Pedestal vs submersible sump pumps

Pedestal Submersible
Motor Above the pit Sealed, in the water
Noise Louder Quieter
Lifespan (HomeGuide) 10 – 30 years 5 – 20 years
Best for Shallow pits, lighter duty Most basements, higher volume

How long do sump pumps last?

HomeGuide puts the range at 5 to 30 years depending on type and how often the pump runs; Angi notes most pumps last 7 to 10 years. A pump that runs constantly through wet seasons wears out sooner.

A sump pump sits in a pit, collects water from drains and pumps it outside.

Signs of sump pump failure

  • Not running when the pit is full, or running constantly.
  • Short cycling on and off.
  • Strange noises: grinding, rattling.
  • Visible rust or a stuck float.
  • Age of 7 to 10 years or more.
  • Water in the basement with the pump connected.

Sump pump not working? Check these first

  1. Power: tripped GFCI or breaker, unplugged cord.
  2. Float switch: stuck against the side of the pit.
  3. Intake: clogged with debris.
  4. Check valve: stuck, letting water flow back.
  5. Discharge line: frozen or blocked outside.

If those check out and the pump still fails, replace it.

Pro tip

Add a battery backup or a second pump if the basement takes on water often. Storms that flood basements are the same storms that knock out power.

Sump pump backups

Backup type How it works Watch-outs
Battery backup pump Second pump runs on a battery when power fails Batteries need replacing every few years
Water-powered backup Uses municipal water pressure to pump Needs city water pressure; uses water
Second primary pump Adds capacity in heavy rain Still needs power
Generator Powers the main pump in outages Must be set up safely, outdoors

Sump pump maintenance checklist

  • Pour a bucket of water into the pit to check the float and pump start.
  • Clean the intake screen and pit of debris.
  • Check the check valve and discharge line.
  • Make sure the outdoor discharge isn't blocked or frozen.
  • Test the backup and its battery.

Sump pump sizing basics

Pump capacity depends on how much water comes in and how high and far it has to be pumped (the "head"). An undersized pump runs constantly and burns out early; a contractor can size it from the inflow and the discharge height.

New sump pit vs replacing a pump

Job What's involved Typical cost
Replace pump in existing pit Swap pump, check valve, test $645 – $2,102
New pit and pump Cut floor, dig, liner, pump, discharge, outlet $600 – $2,500
New pit with interior drain Drain plus pit and pump Priced per linear foot of drain

Sources: HomeAdvisor, HomeGuide.

Where the water goes

The discharge line should carry water well away from the foundation so it doesn't cycle back into the soil. Many areas prohibit connecting sump pumps to the sanitary sewer. In cold climates, the outdoor line needs a freeze-protection fitting so a frozen pipe doesn't stop the pump from discharging.

Frequently asked questions

How much does sump pump installation cost?

About $600 to $2,500 installed, depending on type and whether a pit has to be dug.

How much does sump pump replacement cost?

HomeAdvisor puts replacement at $645 to $2,102, about $1,353 on average.

How long do sump pumps last?

Usually 7 to 10 years, with a range of 5 to 30 depending on type and use.

What causes sump pump failure?

Power loss, stuck floats, clogs, frozen discharge lines, undersized pumps and old age.

Can I install a sump pump myself?

Replacing a pump in an existing pit is a common DIY job. Digging a new pit through a slab and adding electrical work is usually professional.

Does homeowners insurance cover sump pump failure?

Many policies require a water backup or sump pump failure endorsement for water damage from a failed pump. Check your policy.

Do I need a plumber or a waterproofing company for a sump pump?

Either can install one. Waterproofing companies often handle new pits with drains; plumbers commonly replace pumps.

How do I know what size sump pump I need?

Size depends on how fast water enters the pit and how high and far it's pumped. A contractor can measure inflow and discharge height.

Sump pump installation is a one-day job for most homes and protects everything downstairs. Call the number on this page to reach a participating local waterproofing contractor.

Expert review: pending Waterproofing reviewer
Required credential:Basement Health Assoc. certified

Written and fact-checked by DryLevel editors, last updated 2026-11-16. Costs come from the sources linked in the article. Read our editorial policy or report a correction.

Call 1-800-555-0199