Free referral line · Independent guides, every cost sourced Calls answered 24/7 for water emergencies · 1-800-555-0199

Water Damage · Emergency guide

Burst Pipe: What to Do Right Now and What It Costs

Burst pipe in your house? What to do in the first 10 minutes, burst pipe repair costs by location, water damage costs, and what insurance covers.

Short answer

If a pipe bursts, close the main water shut-off first, then switch off power to wet areas and open faucets to drain the lines. Fixing the pipe itself usually costs $400 to $2,000 (HomeGuide). The water damage is the bigger bill: most restoration jobs run $1,361 to $6,282 (Angi). Homeowners insurance usually covers the sudden water damage, but often not the pipe itself.

A burst pipe can release a lot of water fast. The plumbing repair is often the smallest part of the bill; the water it puts into floors, walls and ceilings is what gets expensive. So the first ten minutes matter more than anything you do after.

The first 10 minutes

  1. Close the main shut-off valve. It's usually where the water line enters the house: basement wall, crawl space, utility closet, garage or near the water heater. Turn it clockwise until it stops.
  2. Open the lowest faucets (a basement sink or outside spigot) to drain the remaining water out of the pipes.
  3. Switch off electricity to wet rooms at the breaker panel, if you can reach it without standing in water.
  4. If it's a hot water line, turn off the water heater (gas to "pilot" or "vacation"; electric at the breaker).
  5. Photograph the pipe and the damage before anything is cleaned up.
  6. Call a plumber for the pipe and a restoration company for the water. They're different trades.

Never use a heat gun or open flame to thaw a frozen pipe. If a pipe froze, a split may be hiding behind the ice. Shut off the water before you thaw it so you're not surprised by a flood when it melts.

Why pipes burst

  • Freezing. Water expands as it freezes and builds pressure in the pipe, often splitting it in a spot away from the ice. Pipes in exterior walls, attics, crawl spaces and garages are most at risk.
  • Corrosion and age. Older galvanized steel and some copper pipes thin from the inside.
  • High water pressure. Pressure well above normal stresses joints and fittings.
  • Movement and impact. Settling, a nail through drywall, or a shifted fitting.

Burst pipe repair cost

Where the pipe broke Typical repair cost
Kitchen $150 – $500
Inside a wall $150 – $500
Bathroom $150 – $800
Basement $250 – $5,000
Main water line replacement $2,000 – $5,000

Source: HomeGuide burst pipe repair cost, which puts a typical burst pipe repair at $400 to $2,000 total and $150 to $250 per linear foot of pipe. HomeAdvisor adds that a pipe inside a wall averages about $330 to fix, plus roughly $400 to $1,200 to repair the wall once the plumber is done.

Burst pipe water damage: the bigger bill

The plumber stops the leak. A water damage restoration company deals with what the leak did: extraction, removing wet drywall and pad, several days of drying, then repairs. Most of these jobs land between $1,361 and $6,282, averaging about $3,822 (Angi). A pipe that ran for hours in an upstairs bathroom, soaking the ceiling below, sits at the top of that range or above it.

Water from a supply line is clean (Category 1), which is the cheapest category to dry. That changes if it sits: after a day or two, it can pick up contamination and start feeding mold.

Supply-line water starts clean, but the longer it sits in walls and floors, the bigger the job.

Does insurance cover a burst pipe?

Usually, for the water damage. Most homeowners policies cover sudden and accidental water damage from a burst pipe, including repairs to the home and damaged belongings. Two catches:

More detail in our homeowners insurance and water damage guide.

How to prevent the next one

  • Keep the heat at 55°F or higher when you're away in winter.
  • Insulate pipes in exterior walls, crawl spaces and attics.
  • Open sink cabinets on exterior walls during cold snaps so warm air reaches the pipes.
  • Disconnect garden hoses and shut off outside spigots before the first freeze.
  • Know where your main shut-off is, and test that it turns.
Pro tip

Put a tag on the main shut-off valve and show everyone in the house where it is. In a burst pipe emergency, the difference between finding it in one minute and fifteen is hundreds of gallons.

Where pipes burst most often

  • Exterior walls, especially behind kitchen sinks on outside walls.
  • Attics and crawl spaces with poor insulation.
  • Garages and unheated basements.
  • Hose bibs where the outdoor faucet wasn't shut off and drained.
  • Supply lines to toilets, sinks and washing machines (braided lines that age out).

What a plumber will do

  1. Confirm the main is off and relieve pressure.
  2. Open the wall or ceiling to reach the break (expect a hole).
  3. Cut out the damaged section and splice in new pipe or a repair coupling.
  4. Pressure-test the repair.
  5. Check nearby pipes in the same cold zone; one frozen break often has a neighbor.

The plumber fixes the pipe. Drying the walls, floors and ceiling is a separate job for a restoration company, and it should start the same day.

Burst pipe checklist for your insurance claim

  • Photos and video of the break, the water and the damage, before cleanup.
  • The plumber's invoice stating the cause (for example, freeze break).
  • The restoration company's moisture logs and invoice.
  • Receipts for anything you bought to limit the damage.
  • A list of damaged contents with rough age and value.

If you're away from home

Freeze breaks often happen when a house is empty. Many policies expect you to keep the heat on or drain the plumbing when a home is vacant. If you travel in winter, set the thermostat to a safe minimum and consider a smart leak sensor or automatic shut-off valve.

Frequently asked questions

What should I do first when a pipe bursts?

Close the main water shut-off valve, then switch off electricity to wet areas and open the lowest faucets to drain the lines.

How much does it cost to fix a burst pipe?

Typically $400 to $2,000 for the plumbing, according to HomeGuide, depending on location and access. Water damage restoration is extra and often costs more than the pipe.

Does homeowners insurance cover a pipe burst in the house?

Usually it covers the sudden water damage. The cost to repair the pipe itself is often excluded, and freezing damage in an unheated home may be denied.

Can a burst pipe cause mold?

Yes. If water soaks drywall, insulation or subfloors and isn't dried within about 24 to 48 hours, mold can start to grow.

How long does it take to dry out after a burst pipe?

Many clean-water jobs dry in about 3 to 5 days with professional equipment; larger or slower-drying materials take longer.

Should I turn off the water heater after a pipe bursts?

If the main water is off for a long time, many plumbers recommend turning the water heater to vacation or off to protect it. Follow the manufacturer's instructions.

After a burst pipe, every hour of drying you lose makes the job bigger. Call the number on this page to reach a participating local water damage restoration company, day or night.

Expert review: pending Water damage reviewer
Required credential:IICRC WRTIICRC ASD

Written and fact-checked by DryLevel editors, last updated 2026-11-16. Costs come from the sources linked in the article. Read our editorial policy or report a correction.

Call 1-800-555-0199